Do not rely on the official schematic – the pinout provided, as of Rev A, is incorrect. When you connect the plug, it should look like this:īe sure to build the harness as specified above. Insert that male connector that you built into the factory-provided female connector that looks like this: Take off the left aluminum side by removing the five tapered screws with a 3mm allen wrench. A 4” socket extension bar is very helpful for this step. If you have the new harness (yellow/pink/red/thin green/thick green wires on the signal port), you need to line up the wires on your plug so that they connect to the harness wires according to the following table: Old bike harness It no longer matches the color or pinout in these instructions. Warning: In mid-July 2019, Onyx began shipping a new wiring harness. When you are looking at the side of the connector with the wires, and the latch is on the top, the top row will be blue-white-blank and the bottom row will be yellow-green-blank (see warning below photo before assembling): When you crimp a connector plug to a wire, it should look like this:Īfter crimping the four connections for the harness, insert the connectors into the connector. You are building the male side of the harness. Crimp far end to a 22g 1/4” female connector. Receives +12v when left blinker is active. Receives +12v when right blinker is active. Connects to +12v input of left-signal LED on dash display. Connects to +12v input of right-signal LED on dash display. The harness consists of four distinctly colored wires, each 1’ in length: Thread blinkers through them, and bolt them on just as you did in the front: There are two holes in the side of the rear fender, near the brake light.
Put the mounts on the front fork, thread the blinkers through, and bolt them on: No matter what you see in the pictures that follow, leave your battery disconnected until you are all done. Turn off your battery, physically disconnect its red connector, turn on your dash display to drain any stored currents, and then turn it off. Egofine 1/4 Inch Ratchet Set with 4-13mm and Extension Bar ($14.99).
#Onyx rcr motorbike install#
Mounting bracket for front turn signalsĮverything you need to complete this install is below.Front and back 12V LED turn signals that accept constant current.To complete this project, you will need the following components:
0 kommentar(er)
